|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » X20XEV conversion » Post Reply
|
ed |
posted on 3rd Sep 06 at 16:35 |
Don't need the PAS mount if you have the right kind of C20XE PAS pump ;) | |
teddytopend |
posted on 3rd Sep 06 at 14:57 |
can do you mounts good price. and pas mount. conversionmounts.co.uk also chassis strengthening plates. and tiebar spacers. antiroll bar spacing blocks. :thumbs: | |
ed |
posted on 13th Aug 04 at 18:04 |
Well, there are about 5 working C20XE's for sale on Ebay. If you look properly, then you will find what you are after. If you only want about 130bhp then you but the M-Tec fitting kit for the X20XEV and put that in... Job done. | |
fragpot |
posted on 13th Aug 04 at 14:06 |
I found out from mtec that the mountings are the same. Typically though, the minute I post this an ideal redtop pops up after about 4 months of searching. | |
Rileysport |
posted on 13th Aug 04 at 07:32 |
need spacers to lower anti-roll bar mount... i believe that wiring is different/a nightmare :thumbs: | |
fragpot |
posted on 13th Aug 04 at 05:22 |
Given up looking for a good C20XE so I'm going to put an x20xev ecotec lump in. Any info on this available online? Its got an F20 gearbox on it at the moment. Are the ecotec mounts the same at the C20XE mounts that lee sells? I would need the powersteering brackety thing too. I presume the driveshafts and hubs setup would be the same as the XE conversion as its going to be using an F20. |