|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » bodywork Q » Post Reply
|
Adam-D |
posted on 11th Aug 04 at 18:06 |
cheers | |
3CorsaMeal |
posted on 11th Aug 04 at 15:50 |
i sanded mine down till got rid of as must rust as possible, used wire brush for pitted bits, then use a rust treatment, can't remember the stuff i got but it change's colour when it reacts with the rust, then primer that | |
Adam-D |
posted on 11th Aug 04 at 15:16 |
quote:if you wanted a good match id say yes you can blend it in but its hard to do c-t-c cheers m8 :thumbs: | |
deany |
posted on 11th Aug 04 at 13:48 |
ive got a bit of rust on the bottom of my boot, if i wereto rub it down would i have to paint the full boot? | |
Colour-Tec Coachworks |
posted on 10th Aug 04 at 00:08 |
Grind all the rust out, then Etch prime over the bear metal. Then fill over the etch primer and then go about priming and painting as normal. | |
Adam-D |
posted on 9th Aug 04 at 21:39 |
its in a out of the way place so not too bad | |
JOPO |
posted on 9th Aug 04 at 21:36 |
rub it down mate back to metal n filler over ot smooth it off high build primer rub then paint | |
Adam-D |
posted on 9th Aug 04 at 21:29 |
surface rust |