|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » How to remove...? » Post Reply
|
James@CCC |
posted on 8th May 04 at 12:37 |
I managed it without even jacking it! (im not lowered yet) so u'll be fine just jacking it up. | |
Russ |
posted on 8th May 04 at 09:19 |
if you got little hands (or a gf) you can jack it, other wise, its a bit tricky, but do-able | |
Pickup |
posted on 8th May 04 at 08:41 |
thanks very much for the quick replies :D | |
Kris TD |
posted on 8th May 04 at 08:25 |
backs thre are about 6 10mm hex nuts behind it and one clip. | |
mike_1.2LS96 |
posted on 8th May 04 at 08:23 |
The arches are fiddly. But there is like 6 or 7 plastic bolts on the inner arch, some of these you can get at, others you cannot. So you need to remove the arch lining, which will come out if you remove two bottom plugs, plastic nut near the plugs, one near the top of the wheel and any other ones too. Just pull the arch down so you can get to the nuts. To get the bumpers off is easier, there is two nuts under the bonnet, three under the car, and two in the arch. Not sure about the rear bumper yet. | |
Pickup |
posted on 8th May 04 at 08:14 |
Hey all :) |