|
CRB 553
|
posted on 1st Apr 04 at 19:53 |
cheers mike av just read wot it does...
map (manifold air pressure) - it detects air flow into engine so can add fuel accordingly. Means voltage will vary between 0 and 5 so it cant be tricked.
I dunno wot to do must be a leak sumwhere..!!
|
MikeH
|
posted on 1st Apr 04 at 19:47 |
is map sensor the same as MAF sensor?
i'd be careful about just patching the fault out...you might end up with a dead engine some time down the line.... it is either a real fault or a dodgy connection to the particular sensor.
|
CRB 553
|
posted on 1st Apr 04 at 19:43 |
Right av had this problem that i cant get rid of, engine managment light comes on = map sensor low voltage! (then car will cut out at idle)
Av replaced the inlet gasket and map sensor and checked tubes etc... no luck
It cant go to vaux coz they'l just ask for the ecu connection which it hasnt got coz i swapped engine and didnt set it up.
Any ideas?
I feel like finding the correct voltage andsetting that up across the wires to replace the sensor ......
|