|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Plastic » Post Reply
|
L885 1.28v |
posted on 1st Apr 04 at 15:10 |
cool i will give it a try | |
--Dave-- |
posted on 1st Apr 04 at 14:48 |
yeah that would work, make sure you get some 1200 or 1600 stuff though, nothing too tough. | |
L885 1.28v |
posted on 1st Apr 04 at 14:44 |
what about a bit of wet and dry just to take the ends off | |
--Dave-- |
posted on 1st Apr 04 at 13:59 |
if it's not too noticeable, you could always try one of them soft sanding brushes for the dremel. | |
L885 1.28v |
posted on 1st Apr 04 at 13:46 |
they r not too deep its just the burrs that need removing. | |
--Dave-- |
posted on 1st Apr 04 at 13:27 |
I'm unsure on the pattern cos if you have the "orange peel" type stuff like in mine then you'll need to do the other side so it matches. | |
L885 1.28v |
posted on 1st Apr 04 at 12:43 |
on the left hand side of the H/U on a corsa C | |
--Dave-- |
posted on 1st Apr 04 at 11:04 |
what would heating it up do mate? | |
L885 1.28v |
posted on 1st Apr 04 at 10:51 |
dont really want to paint it what about if i heat it up | |
--Dave-- |
posted on 1st Apr 04 at 09:25 |
could always sand it all down and repaint it? | |
L885 1.28v |
posted on 1st Apr 04 at 09:16 |
Is there any way to remove scrathes from my dash and door card:boggle: |