corsasport.co.uk
  Not logged in [Login - Register]  
You Are Not Registered Or Not Logged In  

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Question about front hubs... » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help
Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

PaulW

 posted on 13th Mar 04 at 15:31

the whole front setup is gona be replaced anyways, so dont matter if the bearings get fooked!


TOMAS

 posted on 13th Mar 04 at 15:28

Sitting a car on its wheels with no shafts through the hubs can fook the front bearings big style mate!


PaulW

 posted on 13th Mar 04 at 15:03

fcukin typical :mad:

Just get the bumper off (pulled off), car jacked up, find a socket the right size & just start going at it to try undo the old bolts & it starts pissing it down :mad:


PaulW

 posted on 13th Mar 04 at 14:44

reet will give it a try then!


Siberia

 posted on 13th Mar 04 at 14:40

just make sure u have the bottom ball joints bolted on anf the anti roll bar and it should roll with no shafts


PaulW

 posted on 13th Mar 04 at 14:37

I've currently got the front of my car up on 2 bricks, as when I fitted the wheels & put it back on the floor, the hubs came off :(

there are no drive-shafts in the hubs, they went with the engine, but they were a bit fooked anyway!

I've got 2 front strut assembly thingies with hubs attached in the garage, reckon if I swap them over they should be ok?

Adam-D says his was on wheels with no shafts in them, but i need to move my car to face the other way in the drive

wana get this done before it gets dark

cheers