|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » crankshaft sensor » Post Reply
|
Wolf In Welsh Clothing |
posted on 14th Feb 04 at 23:40 |
My X16XE would run without it! | |
Big Col |
posted on 14th Feb 04 at 20:01 |
crank shaft sensor went on my C16XE about 2 years ago. It would run but with the ECU in 'get you home mode'. Sounded terrible and it was limited to 4K rpm. It would start but it took about 10 secs of cranking to get it to go. There was no warning it just suddenly went. ECU light comes on. Flashing out the error code shows error code 19. New one was about £35 from Vauxhall. Was a bit of a bugger to fit cos the connection to the loom is under the upper inlet manifold then it routes down the back of the engine to the crank pulley. | |
Red_SXi |
posted on 14th Feb 04 at 19:52 |
My crank sensor went on my 52 plate Sxi, the limiter kicked in at 4,000rpm and it felt like it had pretty much no power | |
Keith Piper |
posted on 14th Feb 04 at 18:54 |
Not crank sensor, if it was it would't work at all | |
corsa_godfather |
posted on 14th Feb 04 at 18:02 |
the odd time when i drive the car gives a slight judder goin up a gearonly ever happens the odd time.my bro says its only a flat spot but ma mate says his astra done it then the crank sensor fucked up | |
jr |
posted on 14th Feb 04 at 10:46 |
well if the crankshaft sensor is'nt working, it won't provide a spark, meaning it won't start :D | |
Kerry |
posted on 14th Feb 04 at 09:39 |
bit more of an explanation would help :lol: | |
corsa_godfather |
posted on 14th Feb 04 at 00:01 |
ttt | |
corsa_godfather |
posted on 13th Feb 04 at 00:20 |
any one know how the car runs before this chucks it????ta |