corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » components and amp HELP... » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

rob_watti

posted on 8th Jan 04 at 18:09

that chart is mad i dont understand it one bit. im still not 100% convinced!


Dom

posted on 8th Jan 04 at 15:30

ok my bad, was looking at hifi drivers not car ones :lol:
lokking on the website (HERE) it doesnt state the impedance, apart from theres this chart, but its a range :boggle:
Although, im sure they'll run off 4ohms no problems, cause ive never seen any 6ohm amps :thumbs:


rob_watti

posted on 8th Jan 04 at 15:07

good man visibleman i think im definately guna fork out and get the the focal 165 k2p comps. Wot is the focal website mate?


Dom

posted on 8th Jan 04 at 15:00

no focals run at 4ohms mate ;)
rob - i checked that website you (i think it was you) were looking at and the information was incorrect, because the focal website states they were 4ohms.

However, andy, even though JL stuff is top notch, you dont exactly get best power for your buck mate :( although the focals are only rated at 60wRMS and the JL amps is 45wRMS @ 4ohms, so not much of a problem but your not gonna get the most outta them :(
But still mate, it will sound MINT :thumbs:


rob_watti

posted on 8th Jan 04 at 12:53

dont focals run at 6ohm??? therefore u would not be using the full power of your, so would b wasting power! i think so anyway, i aint 100% sure so dont hold me to it


Andy GSi

posted on 8th Jan 04 at 10:38

well after spending so much on subs and amp for that, i have to cut my budget down now!!:(

so what do u think of these two??



Stereo: 2 x 45 Watts RMS at 4 Ohms; 2 x 75 Watts RMS at 2 Ohms
Bridged: 1 x 150 Watts RMS at 4 Ohms

Input Range: 200 mV - 8V RMS
THD at Rated Power: <0.08% at 4 Ohms per ch.
Signal to Noise Ratio: >104 dB referred to rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Frequency Response: 10 Hz - 25 kHz (+0, -1dB)
Damping Factor: >200 @ 4 Ohms per ch. / 50 Hz.
Slew Rate: > 22V/µs
Dimensions (L x W x H): 9.8” x 9.25” x 2.36”

componets:

focal 165 6.5"