|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Getting power cable into car? » Post Reply
|
IntaCepta |
posted on 26th Dec 03 at 22:10 |
but if the power cable has an inline fuse, u'll only be able to wire it into the cabin from the engine bay. | |
wainey |
posted on 26th Dec 03 at 17:09 |
quote:no need for battery to come out if u feed it from the inside out!;) just pokes out behind the header tank, then u just grab it:) | |
Adam |
posted on 26th Dec 03 at 00:03 |
quote: they fit grommets to stop the wire chafing on the metal bodywork and causing it to short out, really should have gone through it [Edited on 26-12-2003 by Adam] | |
IntaCepta |
posted on 25th Dec 03 at 23:26 |
lol @ pen and chopstick | |
Sparco |
posted on 24th Dec 03 at 18:16 |
i used the gromet which is on the drivers side, at the top left of the engine bay, seemed alot easier to do that than take all the battery and that out. power down drivers side, everything else down passenger side. | |
the_legend_of_yrag |
posted on 24th Dec 03 at 14:55 |
Finnaly got the other cables thru the otherside, but whilst doing that, my handbrake decided to come off, and as my car is on a slope, it gradually proceeded to move forwards into my house, big dent in bonnet, broken headlight bracket, and broken bumper bracket. | |
Nath |
posted on 24th Dec 03 at 14:11 |
i secured the amp wire to a chop stick then jammed it underneath the gromet and just thread it through. Simple! I didnt pierce mine either. Thought it was sealed for a reason. | |
the_legend_of_yrag |
posted on 24th Dec 03 at 13:28 |
Yesh done it shoved a pen thru to make a hole then shove the cable through lol. | |
scoob |
posted on 24th Dec 03 at 12:50 |
it is abit fiderly | |
IntaCepta |
posted on 24th Dec 03 at 12:24 |
just thread it thru, from the engine bay into the cabin. | |
the_legend_of_yrag |
posted on 24th Dec 03 at 12:20 |
hhmm ok ill see what i can do! | |
scoob |
posted on 24th Dec 03 at 12:18 |
i just cut a hole in mine and pushed i thru | |
the_legend_of_yrag |
posted on 24th Dec 03 at 12:14 |
Need to get my amps power cable thru into my car and in the maxpower haynes manual it says it can easily go through an existing gromet? |