|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Headunit help » Post Reply
|
NormSXi |
posted on 11th Nov 03 at 20:45 |
quote: Spot on with the colours AustinPXX!! Purple (rear right +) purple/black (rear right -) grey (front right +) grey/black (front right - ) white (front left +) white/black (front right - ) green (rear left +) green/black (rear left -) According to my Kenwood manual, and i know the wire colours on my corsa C match that exactly:D You need to make sure you have the permanent and switched lives wired corectly mate, or the HU won't store radio presets or settings when you turn the ignition off! The back of your factory HU should have markings saying which pin is which, mine does, so you could trace the connections from there maybe? hope some of this rambling helps! :lol: | |
break |
posted on 11th Nov 03 at 13:05 |
Thanks alot AustinPXX. | |
Richie |
posted on 10th Nov 03 at 23:30 |
http://www.tonkins.com.au/frameset/tonkins.htm | |
break |
posted on 10th Nov 03 at 23:25 |
Where can I get one of these ISO adapters (I'm in Australia so an online store with international post would be essential) | |
Richie |
posted on 10th Nov 03 at 21:11 |
The manual will give you most details of which wires are which for your headunit if they arent labelled, then you just match them up with this on the ISO loom | |
Stu_22 |
posted on 10th Nov 03 at 21:06 |
Thats what I thought any where got a diagram of which wires go where | |
Richie |
posted on 10th Nov 03 at 19:55 |
Best thing you can do mate is buy an autoleads ISO extension, cut off the block with no pins in it, and match em all up. US/JAPAN ect dont follow ISO. | |
Stu_22 |
posted on 10th Nov 03 at 18:59 |
Just bought a new pioneer headunit, got it from hong kong as it was cheaper. |