any more info appreciated.

Cheers

anyone else kno what the

Thick Black

and

Thick Red

mean and where theyre meant to go?

there always is when i do them. il try and look 2nite

cheers lee,

but on the 9plug connection in the footwell im left with

Thick Black

Thick Red

Where do i connect these as there aint a corresponding colour on the 2litre loom

use the corsa starter motor loom. that will hae a plug on the end that plugs into the original place. ur then left with 9 wires in the drivers footwell and 9 wires on the 2 litre loom by the header tank or near the ecu depending on loom. all u have to do is extend the wires from the ones in the footwell to the 2 litre loom. colour to colour

ttt

cheers mate

anyone kno what the thick red is for anyway, whether its needed or not!

dont think thick red goes anywhere, thick black is ECU live and needs a 12Vignition feed. might need to run new wire for it then crank it over, hehe

i have matched all colours in car and am left with

Thick Red

and Thick Black

where do these go?

thin blue wire on calibra loom is coolant sensor if i remember correctly and there should be thin blue in car on corsa loom. black/brown is a diagnostic one and that too should be in car on corsa loom.

You havent connected any wires in car??? think we connected 6/7 when we did mates corsa, was just a case of matching wires up.

only connected 3 on multiplug

[Edited on 01-09-2003 by quiksilver106]

any ideas ppl?

ttt plz hlp

if you have no luck with your problem i will see a lad tonight who did all my wireing for me , its a bit risky if youre not sure.

yes ive used the corsa loom to the engine starter, alternator and rev light switch etc etc


Its just the 9 pin plug next to the ECU location in the drivers footwell

have you put the corsa loom that goes to starter motor and alternator on or used the calibra one . you have to use corsa one.

Done a search and could not find any answers to what im looking for so here goes.....


On my 9 wire multiplug ive linked all the wires colour - colour and am left with......

Corsa Car loom

Thick Red

Thick Black


Calibra 16v Engine loom

Thin Black Red Trace

Thin Red - White Trace

Thin Black - Red Trace

Thin Black - Brown trace

Thin Blue wire


Can anyone tell me what wire i connect to what to complete the connection.

Cheers