|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » 2.0 16v wiring questions » Post Reply
|
jjcymru |
posted on 6th Sep 03 at 20:18 |
any more info appreciated. | |
jjcymru |
posted on 5th Sep 03 at 07:34 |
anyone else kno what the | |
lee mitchell |
posted on 4th Sep 03 at 17:27 |
there always is when i do them. il try and look 2nite | |
jjcymru |
posted on 4th Sep 03 at 07:26 |
cheers lee, | |
lee mitchell |
posted on 4th Sep 03 at 05:36 |
use the corsa starter motor loom. that will hae a plug on the end that plugs into the original place. ur then left with 9 wires in the drivers footwell and 9 wires on the 2 litre loom by the header tank or near the ecu depending on loom. all u have to do is extend the wires from the ones in the footwell to the 2 litre loom. colour to colour | |
jjcymru |
posted on 3rd Sep 03 at 12:19 |
ttt | |
jjcymru |
posted on 1st Sep 03 at 21:54 |
cheers mate | |
quiksilver106 |
posted on 1st Sep 03 at 21:47 |
dont think thick red goes anywhere, thick black is ECU live and needs a 12Vignition feed. might need to run new wire for it then crank it over, hehe | |
jjcymru |
posted on 1st Sep 03 at 21:44 |
i have matched all colours in car and am left with | |
quiksilver106 |
posted on 1st Sep 03 at 21:39 |
thin blue wire on calibra loom is coolant sensor if i remember correctly and there should be thin blue in car on corsa loom. black/brown is a diagnostic one and that too should be in car on corsa loom. | |
quiksilver106 |
posted on 1st Sep 03 at 21:35 |
You havent connected any wires in car??? think we connected 6/7 when we did mates corsa, was just a case of matching wires up. | |
jjcymru |
posted on 1st Sep 03 at 21:22 |
any ideas ppl? | |
jjcymru |
posted on 1st Sep 03 at 14:04 |
ttt plz hlp | |
p16vlv |
posted on 1st Sep 03 at 13:29 |
if you have no luck with your problem i will see a lad tonight who did all my wireing for me , its a bit risky if youre not sure. | |
jjcymru |
posted on 1st Sep 03 at 13:18 |
yes ive used the corsa loom to the engine starter, alternator and rev light switch etc etc | |
p16vlv |
posted on 1st Sep 03 at 13:08 |
have you put the corsa loom that goes to starter motor and alternator on or used the calibra one . you have to use corsa one. | |
jjcymru |
posted on 1st Sep 03 at 12:58 |
Done a search and could not find any answers to what im looking for so here goes..... |