|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Crazy induction kit idea » Post Reply
|
Wolf In Welsh Clothing |
posted on 19th May 03 at 13:55 |
Or get ripped off £250 for a pipercross viper. | |
StuartGee |
posted on 19th May 03 at 10:07 |
Drill an extra big hole approx 50 - 60 mm diameter, and run a piece of tubing from this down under headlight. There is a low/high pressure (cant remember which) area here, so the cold air is sucked up and into airbox. Or run it to your grille as you wouls with induction kit. | |
dig dave2811 |
posted on 19th May 03 at 08:40 |
where do u run a cold air feed from if u have drilled your air box? | |
Cybermonkey |
posted on 19th May 03 at 08:22 |
Actually heres a better idea. bin the fucking induction kit, they are poo. Get yourself a nice standard airbox, drill it, fit a good K&N performance panel filter, give it cold air and you shall have better performance than any stupid sponge filter. | |
Gambit |
posted on 19th May 03 at 08:19 |
it would get soaked also on wet days | |
Kris TD |
posted on 19th May 03 at 08:19 |
the longer the pipe, the quieter it becomes. | |
Cybermonkey |
posted on 19th May 03 at 08:11 |
I would not do this if i were you. Ideally, you want the filter to be as close to the inlet plenum as possible. Putting it further away means that the air will have more difficulty travelling into the engine. If you want better performance, leave it where it is, since this place is the best trade off for heat/length. Just feed it plenty of cold air. | |
MikeH |
posted on 18th May 03 at 23:40 |
You mean use the cold air feed pipe as an extension pipe to move your induction cone lower down? | |
birdy_sri |
posted on 18th May 03 at 23:38 |
no i dont get ya mate sorry !! | |
westsidecorsa |
posted on 18th May 03 at 23:33 |
right, if i put the cold air feed straight from the tube in the engine where the airbox usually goes and run it to my iduction kit which would be placed down in the bottom grille( where the cold air feed pipe usually goes) would this make a difference, so basically..instead of running a cold air feed to the induction kit, put the tube on the induction kit to the engine, if u get me?? |