|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » c20xe help » Post Reply
|
Richardhhha |
posted on 12th Jun 08 at 23:25 |
is it primeing? If not then check your wiring. All your problems could be something daft like a earth problem... Lol, if your still getting no luck, drop lee mitchell a message... Always been refered to him when asking about fitting a xe or a let.... | |
stuartswan |
posted on 12th Jun 08 at 23:20 |
yes the fuel pump realy is plugged in | |
Richardhhha |
posted on 12th Jun 08 at 23:09 |
ok no fuel and no spark.... Your fuel pump isn't working for one.... Is the fuel pump relay pluged in... Also no spark... Make sure the roter arm in the distributor is there.. Or the coil pack is plugged in, and the crank position sensor is plugged in! Also the ht coil (if dizzy type) is plugged in properly... | |
sand-eel |
posted on 12th Jun 08 at 22:27 |
if the CTS was not registering because of no coolant......might be it maybe? | |
stuartswan |
posted on 12th Jun 08 at 22:23 |
we cant get this to start, its cranking put no fuel and no spark, the only thing i can think of is the red wire on the 9 pin plug at the drivers footwell. where is this meant to connect to? | |
Richardhhha |
posted on 12th Jun 08 at 17:14 |
if you dont ahve a Air flow meter pluged in it will be a git to start.. | |
stuartswan |
posted on 12th Jun 08 at 17:11 |
we have fitted a c20xe to a corsa and trying to get it to start, its only turning over now, does anyone know what sensors need plugged in for it to start? we dont have any airbox, exhaust mainfold or cooling system. are any of these needed to try and start the engine? thanks |