|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » No Spark » Post Reply
|
eastend |
posted on 13th Nov 07 at 22:54 |
thanks mate :) | |
Richie |
posted on 13th Nov 07 at 22:49 |
Okely dokely. Ill be on here tomorrow for 11am onwards armed with my superior wiring knowledge of Corsa's :) | |
eastend |
posted on 13th Nov 07 at 22:46 |
ok well i will have to do that tomo. i get my chip for my key tomo aswel so hopefully i will put the x16xe ecu and transponder in and it may fire. because like you said it may not work on the x14xe ecu and transponder. | |
Richie |
posted on 13th Nov 07 at 22:40 |
Ok then you need to get a multimeter out. | |
eastend |
posted on 13th Nov 07 at 22:36 |
just did the earth thing and still no spark :( | |
Richie |
posted on 13th Nov 07 at 22:34 |
quote: I wouldnt be too sure of this either especially if there is a large year gap between the engines. I had two x12xe blocks and they were 4 years out...... turns out the ecu on the older one couldnt work with the coilpack on the newer block as it used a different signal. | |
Dean_W |
posted on 13th Nov 07 at 22:32 |
What richie is saying is that if you have a dodgy earth on the engine, make a lead up. This will then earth the whole lot. | |
eastend |
posted on 13th Nov 07 at 22:29 |
the engine will definately run on the x14xe ecu and were not trying to find a battery earth but one on the engine | |
Richie |
posted on 13th Nov 07 at 22:27 |
I dont think the x14xe ecu will let it fire? | |
eastend |
posted on 13th Nov 07 at 20:11 |
could someone possibly list where all the engine earths are located please as i cant remember all the locations. | |
Vaux Lad |
posted on 13th Nov 07 at 16:26 |
Crank sensor | |
eastend |
posted on 13th Nov 07 at 14:33 |
already changed them over from my old engine as i thought that maybe the prob but still no spark :( | |
Hamish |
posted on 13th Nov 07 at 14:31 |
coilpack/ HT leads? | |
eastend |
posted on 13th Nov 07 at 14:22 |
well the light was flashing because i am waiting to get the chip but i am using the 1.4 ecu atm just to get it started. | |
Richie |
posted on 13th Nov 07 at 14:18 |
Is the engine management light flashing? Have you got the transponder chips to match the ecu for the x16xe? | |
eastend |
posted on 13th Nov 07 at 14:07 |
I have just completed my conversion from the x14xe to the x16xe and currently i am not getting a spark! |