|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » help please please????? » Post Reply
|
Dave A |
posted on 7th Jul 07 at 14:41 |
quote: cant check timing marks by finding tdc with a screwdriver as TDC is about 15-20 degrees out from the timing marks on a c20xe. | |
luke gsi16v |
posted on 7th Jul 07 at 12:10 |
i will have to have a look at that | |
craig_s |
posted on 7th Jul 07 at 12:09 |
its just like a plug that had a bolt through the middle of it going on to the block.it would probably still run though.so i doubt it would be that.if i was you i would check the timing then do a fault code test | |
luke gsi16v |
posted on 7th Jul 07 at 12:07 |
put a new head that has bin rebuilt an it was clean. wats the knock sensor look like | |
craig_s |
posted on 7th Jul 07 at 12:04 |
you need to check tdc with a screw driver really.don't just rely on the marks.did you empty the hydraulic lifters too? | |
luke gsi16v |
posted on 7th Jul 07 at 12:03 |
lined all the marks up | |
craig_s |
posted on 7th Jul 07 at 12:00 |
how did you time it up?using the original marks?or did you check tdc with a screw driver? | |
luke gsi16v |
posted on 7th Jul 07 at 12:00 |
its turnin over yh but not hardly firin, timin mite be wrong | |
craig_s |
posted on 7th Jul 07 at 11:58 |
nah no nockin noise.mine just ran like crap over fueling and smoking.is it turning over? | |
luke gsi16v |
posted on 7th Jul 07 at 11:58 |
so u had a knockin noise to?? | |
luke gsi16v |
posted on 7th Jul 07 at 11:57 |
not yet no | |
craig_s |
posted on 7th Jul 07 at 11:56 |
on teh back of the engine under the inlet manifold.its easier to get at from underneath.have you done a fault code test on it? | |
luke gsi16v |
posted on 7th Jul 07 at 11:54 |
cums on now an again were is the knock sensor | |
craig_s |
posted on 7th Jul 07 at 11:53 |
running rich could be a couple of things mine was doing this.partly because the lamba sensor had gone and the nock sensor was unplugged.is your eml light on? | |
Dave A |
posted on 7th Jul 07 at 11:48 |
get it tested on a RR to find where and why its running rich | |
luke gsi16v |
posted on 7th Jul 07 at 11:37 |
yh thats were it was, its usin more fuel, wat cud that be then to solve it | |
Dave A |
posted on 7th Jul 07 at 11:30 |
usually the fire ring between 2 cylinders goes between 3 and 4 on these engines. can happen over time with normal wear and tear etc... can be a sign of running lean as well. | |
luke gsi16v |
posted on 7th Jul 07 at 10:55 |
my car started knockin the other day from top end an lost all power, took the head off an found nothin wrong wit the valves an that, but it blew a piece out the head gasket between the 2 pistons like burnt it away. i replaced the head wit a new one today an now it want fire up, also did compresson test an was fine? |