|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » removing spare wheel well » Post Reply
|
mike16v |
posted on 21st Feb 03 at 15:45 |
how much could u do it 4 desmond?? | |
Desmond |
posted on 21st Feb 03 at 15:39 |
Best thing to do is cut it out appart from the bit witht the break bias valve (if your car has one) then plate over using spot weld, dont fully weld as you could warp your car :o then under seal it all and then put a piece to strengthen the bias bit so its like a triangle.... hard to explain but not hard to do | |
mike16v |
posted on 21st Feb 03 at 15:22 |
ok thanks alot m8 | |
Daimo B |
posted on 21st Feb 03 at 11:18 |
Oh, u'll need to make a new bracket to hold the brake lines and rear brake compensator too. | |
Daimo B |
posted on 21st Feb 03 at 11:17 |
Pretty m uch yeah. You'll need to underseale all the underside though. | |
mike16v |
posted on 21st Feb 03 at 11:13 |
is it just a case of cutting it out and weld a sheet of metal over it?? |