|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » 2.0 conversion difficulty » Post Reply
|
Rich_J_Williams |
posted on 5th Jan 07 at 09:17 |
http://www.vauxhallsportforum.com/phpBB2/20xe-into-a-corsa-t106.html | |
BeArDy |
posted on 5th Jan 07 at 08:35 |
quote: :lol::lol::lol::lol: take it you have never fitted one to a 1lt 12v Can be done just the wiring side is differant on the 1lt 12v as the engine is a non vauxhall and the ECU is in the engine bay, on the side of the engine..... | |
Fro |
posted on 5th Jan 07 at 08:22 |
Think its to do something with the fact its a 12v but not completely sure... | |
Wonderboy |
posted on 4th Jan 07 at 20:47 |
Putting a 2 litre engine inplace of a 1l ? Wont that be a huge job ? How much would that cost from a garage ? | |
Ben ev |
posted on 4th Jan 07 at 20:23 |
easy money. ecu has one multi block and about 6 wires wich go up the drives side of the dash and one to the rear for fuel pump. everythings colour coded the same and diagrams are widely availible. then have a few gearbox side , oil press switch etc. can use corsa loom for starter and alternator so piss easy. think there is also ignition live that end. | |
Pete B |
posted on 4th Jan 07 at 17:57 |
Iv put both my engines in my corsa with help for my mate. if you have all of the loom and the ECU and all you have to do is hook up 7 wiers 3 to the starter moter 1 to the ecu (black / yellow) 1 water 1 revs 1fule pump. | |
dan_almond |
posted on 4th Jan 07 at 15:37 |
Heres the story. |