|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Speedline centre caps - how to fit? » Post Reply
|
dan_almond |
posted on 13th Nov 06 at 14:07 |
have you managed to get the grease caps off the front yet? | |
Arctic_Monkey |
posted on 13th Nov 06 at 14:02 |
Cheers guys, didn't realise they were such a bitch to fit...the rear p/s pops on no bother for some reason but the rest are just being a cunt | |
dan_almond |
posted on 13th Nov 06 at 12:23 |
with the front ones. take the grease cap off (bit of a bitch to do) and then use some snips to cutt the cotter pin back. the pin bends back on itself, just cut it as the bend. then they shoud fit spot on. | |
Dave Hay |
posted on 12th Nov 06 at 22:19 |
i ground some off the hub too but be careful as it has to be flush | |
adam_81_uk |
posted on 11th Nov 06 at 17:57 |
u may have to bend the cotter pin out the way to fit caps thats the pin that goes through the hub nut or the driveshaft in some cases u hav to grind some material of the end of the driveshaft but thats rare | |
Arctic_Monkey |
posted on 11th Nov 06 at 14:26 |
As above, i've only managed to get one on at the back...a know the front ones are more difficult but should they just pop on once the grease caps are out the way? Cheers |