as ed said block it first with 1500 or 2000 then g3 the car (with a electric buffer) when you g3 it use plenty of water and keep adding water till it runs clear, (also don’t buff over any high lines or you’ll end up going through the paint) then give it a good waxing seeing as winter is just round the corner.

no runs just very small little bobbles must be coz i aint in a dust free area

thing is tho i used g3 wiv water and it never seemed to dry then after i left it once all the compound cleared up it all went cloudy is that when i should be using a Farécla Finishing Cloth

Is it rough? You can block out the runs using some 1500 and 2000. Any rough bits will need to be macine polished with some compund.

quote:

---

Originally posted by ed
What paint though...

---

What paint though...

quote:

---

Originally posted by ed
How have you painted it?

---

have a look here.......

http://www.farecla.com/index2.asp?id=346&stage=G3%20-%20How%20to%20use&set=4

if you have never used a polisher before pratice on an old panel frist or where it wont notice

[Edited on 08-10-2006 by flash22]

How have you painted it?

Question for people who know anything about spraying

I have just finished spraying ma old corsa Flame red when the paint has dried how do i go about getting a highly polished finish

i have a tub of 3g or g3 compound not quite sure how to apply and remove ie machine it on and hand polish off or apply by hand and machine polish off

lots of help and advice is needed and is very appreciated :thumbs: