|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » URGENT HELP NEEDED » Post Reply
|
c4rsa-sport |
posted on 28th Jun 06 at 16:01 |
picked up my car today and the problem was solved by swapping the calipers over, there is stil a bit of sponge in the pedal but brakes work good, will braided lines solve the sponge feeling? | |
c4rsa-sport |
posted on 27th Jun 06 at 18:47 |
cheers again m8 i will let you know how i get on tomorrow | |
Joe |
posted on 27th Jun 06 at 18:40 |
You do mate, i work in a garage and did'nt know that it made a difference and the lad who gave me a hand didnt he's supposed to be qualified too. was one of the other more experianced lads who told me. | |
c4rsa-sport |
posted on 27th Jun 06 at 18:28 |
as for the master cylinder i think i may of caused this as i was pushing the pedal to get the fluid through, so thats probably my fault, thanks for that explaintion this helps such a lot as i am lost without my car i will let the garage know asap tomorrow cheers again... i suppose you learn from your mistakes | |
Joe |
posted on 27th Jun 06 at 18:22 |
Yes you should. Basically the fluid which is in the caliper will have air in it, so when you bleed them pushing all the air out if the nipple is at the top the air from the bottom of the caliper goes up and out with some of the fluid. | |
c4rsa-sport |
posted on 27th Jun 06 at 18:11 |
ok then i will go down there tomorrow and tell them to swap them over, and when they are at the top i should have brakes then? explain to me again why they are not working now? well when he took the old cylider off parts where ratteling inside?? | |
Joe |
posted on 27th Jun 06 at 18:06 |
Yes swap the calipers from side to side so the Nipples are at the top. Nope you probably did'nt need the new master cylinder, although the garage should have noticed the nipples were upside down and said that to you. Especially if they suggested it but didnt think it would make 'much difference' | |
c4rsa-sport |
posted on 27th Jun 06 at 17:54 |
the nipple is at the bottom, so if we change the nipple over so its at the top they wil work, so really i didnt need a new master cylinder? | |
Joe |
posted on 27th Jun 06 at 17:47 |
The bleed nipple NEEDS to be at the top, otherwise you will never get them to bleed. If the nipple is at the bottom you cant get the air out from the top of the caliper. Is the nipple at the top or the bottom? | |
c4rsa-sport |
posted on 27th Jun 06 at 17:43 |
i havent no the guy did suggest this but does it really make that much of a difference, so if the calipers got changed over would it work ok? | |
Joe |
posted on 27th Jun 06 at 17:38 |
Have you got the calipers on the right sides? When i fitted mine I put them on the wrong sides and I could'nt get them to bleed up at all. The bleed nipple should be at the top of the caliper. | |
c4rsa-sport |
posted on 27th Jun 06 at 17:09 |
i bought some 2.0 brakes and discs, i fitted them on sunday but when i went to drive off i discovered i had no brakes, i bleed the brakes through again but still no brakes. so i took my car down the garage and left it up to them to sort it out, went back today to see how there getting on they told me the seal in the master cylinder had rolled:boggle: they got a new one fitted bleed all the brakes through including the rear but yet still i have no brakes, does any body know what this could be??? |