thats what i did, i found 1 stabbing me in the back in bed, but the other 3 i have no clue

:lol:

oh ffs

took pins out and cant remember where i put them pmsl

mine have no pins, i lost them. worked fine so far

No , this is difficult to explain.

Right, on your lifters are two rounded pieces , with the bolts attatched.

Take the bolts off by taking out the wee pin holding them in. ( Do not throw away)

Go and put the bolts on the wing , and the bonnet.

Now put the strut over one bolt , and relocate the pin.

Stretch it to the next bolt and once again the pin ........

yer they arnt attatched to any bolts,should i do this yeh? bolts on at each end then,on as one?

Are you trying to put the lifters on as one or have you taken off the bolts at either end ?

i removed the bolt on the bonnet/bonnet hinge nearest the screen, and then it became fairly obvious which bolt to remove in the wing...

taken what out mate...:lol:

Have you taken them out of the little bolts that they pivot inside ?

rite got some of these

now iv put the bolts in the holes closest to the bulk head (theres 2 bolts, about an inch from each other) is this right?,as i cant seem to get the fookers on:o

and which way do they go on?? with the base on the wing and the ram on the bonnet?

helppp:(