wide masking tape?
joiners clamps? forget what they're called, but ones with a trigger type handles that pulls rubber suckers in tight. could clamp to the sill from the inside

anyone? I;m sure i've heard some ppl on these boards saying how they've bonded their side skirts on.

I'll be bonding my new skirts with tiger seal too. Can anyone give me any advice on how to keep the side skirt in place for 8 hours when the tiger seal is bonding? What could i use to do this?
Also i plan to put a few selftapers in each arch also when the glue is dry.

i put silicone one each screw i put in to protect from rust, the clips seem to hold it well

the clips are shit though.
i'd do both.

the sealant will also probably cover the holes that you've drilled, so you shouldn't have rust probs.
dab a bit of red oxide over the holes to be sure :thumbs:

22p each for the proper clips mate, worth it in the long run, easy to fit. i bought 18 of the @22p each = approx £4 . probably cheaper than sealant

anyone used jsut this then any hints, just goign to hold it in place with duc tape till the tiger seal goes off :D

tiger seal is the stuff. Just as good as ANY fixing. You can get it from any motor factors

just do dont wanna drill holes in the car to be honest, tex flex is what the old etypes bonnets were held together considering the bonnet weigh bout half a tonne and they go 50mph it should m be ok

motr factors?? IMHO I would go to vauxhall anf buy the proper fittings they dont cost much

going to use tex flex,tiger sealsomething along those lines to put my gsi skirts on. where can i purchase this?