|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » big block hubs into smallblock knuckles » Post Reply
|
rodgerq |
posted on 31st Jan 06 at 00:32 |
quote: can you explain exaclty how its bullshit? then i'll go about explaining how its NOT bullshit rodgerq | |
alistairolsen |
posted on 31st Jan 06 at 00:27 |
Well thanks a lot for all your help. i dont have the required 6 figure salary for this site it would seem. I dont want 22 spline shafts as I WILL kill the outer cvs. I dont want machined hubs and std smallblock bearings as they will snap and kill me, anyone using these must be retarded or suicidal. You cannot fit unmodded big block hubs to std knuckles as there isnt enough metal to mount the new bearings, so we are left with the HH grp A stuff, which is a golf synchro rear wheel bearing mounted in a bored out knuckle with a std hub. OD of bearing is only 68 in comparison to the vaux 72mm, but ID and width are 39 and 37mm respectively, same as the std stuff. | |
jamied |
posted on 31st Jan 06 at 00:23 |
wheres the best place to get fitting kits?i was thinking of buying everything aprt from mounts as ive been told guy off mig does cheap | |
ed |
posted on 31st Jan 06 at 00:16 |
:rolleyes: | |
alistairolsen |
posted on 30th Jan 06 at 23:56 |
thats what im sking, grp a nova big block bearings were machined out knuckles, std big block hubs and these golf bearings. what i want to know is if anyone on here has done it and knows sizes? HH will tear me a new arsehole before selling me parts | |
ed |
posted on 30th Jan 06 at 23:28 |
Get a Harry Hockley set up then. | |
alistairolsen |
posted on 30th Jan 06 at 19:07 |
I want to machine the huge cast steering knuckle to take std cally hubs. | |
Siberia |
posted on 30th Jan 06 at 19:04 |
well then... you need to get your wallet out and buy some mtech hubs:P... i really wouldnt reckomend you go machining astra/cav hubs | |
alistairolsen |
posted on 30th Jan 06 at 18:57 |
the way i drive, I really cant see that lasting! I really want the big block outers tbh, 1) so i can run equal length shafts, and 2) COS ITS STRONGER! | |
Siberia |
posted on 30th Jan 06 at 18:52 |
forget all or that.... use you corsa hubs... corsa gsi outer cv joints... corsa gsi drive shafts and mark 2 cavailer inner cv's... | |
alistairolsen |
posted on 30th Jan 06 at 18:37 |
. | |
alistairolsen |
posted on 27th Jan 06 at 17:57 |
boing | |
alistairolsen |
posted on 26th Jan 06 at 20:29 |
Need to fit big block hubs into small block knuckles for an xe conversion. I dont want to machine the hub, so I have heard you can use golf synchro bearings? |