|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Where has the date gone? » Post Reply
|
Ricky-Lee53 |
posted on 5th Jan 06 at 11:18 |
Is it TA??? think it is... press that button and it will reappear. | |
Phil McGlassup |
posted on 2nd Jan 06 at 18:31 |
Thanks for that, it's just that my Corsa has no rear speakers whatsoever -so what should I do? | |
tom_simes |
posted on 2nd Jan 06 at 18:22 |
As far as I am concerned, and a couple of my mates, we have all just fitted a good set of components in the front and a sub in the boot, and just left the rears standard, as the front produces such good sound, all the rear does is provide all round sound, rather than be the main speakers. | |
Phil McGlassup |
posted on 2nd Jan 06 at 18:19 |
When fitting components to the front, where do the tweeter parts fit? I guess they fit above the door handles (as per the standard fiting in my Vectra) but is there enough room for them as they look a tad too big to fit comfortably? | |
tom_simes |
posted on 2nd Jan 06 at 18:01 |
quote: yep!! :thumbs: mine are running off my headunit at the moment, but will be from an amp in around 2 weeks, when I get around to running the cabling for my amp to the components in the boot, along with the active sub [Edited on 02-01-2006 by tom_simes] | |
Planty02 |
posted on 2nd Jan 06 at 13:52 |
fronts are prob better through an amp but i run mine str8 off the HU n theyre fine (depnds on ur HU) | |
Phil McGlassup |
posted on 2nd Jan 06 at 12:51 |
Would front components sound better if they are amplified? | |
tom_simes |
posted on 2nd Jan 06 at 00:57 |
yes, that will be no problem, although I would recommend if you can afford it, fitting a set of components in the front and having a four channel amp to run the sub and front speakers. It makes sense to run the new speaker cable at the same time as the power and RCA then. Hope this help you. | |
Phil McGlassup |
posted on 1st Jan 06 at 21:20 |
Thanks for the feedback everyone:) the MFD now works as it should! | |
RKS |
posted on 1st Jan 06 at 11:45 |
The blue wire will be used to switch your amps on, however you will need to remove it from the vauxhall loom to do this anyway :) | |
Jake |
posted on 30th Dec 05 at 21:12 |
the blue wire will be needed for the amp. | |
Phil McGlassup |
posted on 30th Dec 05 at 19:32 |
Thanks dude:thumbs: | |
RKS |
posted on 30th Dec 05 at 17:55 |
in the wiring loom going from the HU to the corsa loom, there will be a blue wire. either remove or cut this wire, making sure to tape up both ends of the wire | |
Phil McGlassup |
posted on 30th Dec 05 at 17:52 |
I have just fitted a replacement cd/tuner and have found that whenever it is switched on the date of the Multi Function Display unit goes out:mad: When it is switched off or disconnected the date is OK. When it switched is on and I press the top left button of the MFD the date appears and can be set - but goes out after a few seconds!! |