|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » c16xe/x16xe » Post Reply
|
Cybermonkey |
posted on 12th Jul 05 at 05:54 |
thanks Greg :) | |
Greg_M |
posted on 12th Jul 05 at 05:46 |
yeah lower inlet manifold is different on the x16xe compared to the c16xe. | |
Cybermonkey |
posted on 12th Jul 05 at 00:38 |
Sam, i was wondering about the whole tract from the airbox backwards, but i reckon it must be very similar. | |
Sam |
posted on 11th Jul 05 at 09:55 |
C16XE inlet manifold drawing from EPC: | |
RobHayes |
posted on 11th Jul 05 at 09:53 |
quote: did think of the egr, and was plannin on blanking it off. i cant see them being that different. to fit a mantzel onto a c16xe u use bits off a x16xe inlet? | |
Cybermonkey |
posted on 11th Jul 05 at 09:45 |
quote: Rob, i have never seen the inlet from a C16, but i would guess they are different, and also the C16 has no EGR valve, so you would have to fit a blanking plate to the inlet? | |
RobHayes |
posted on 11th Jul 05 at 09:38 |
i know there is a throttle position sensor, the coolant temp sensor, crankshaft sensor??, and then theres the plug onto the distribution block thing, and a plug onto each injector, lambda sensor, inlet air temp (which is just clipped up out the way) | |
Stu_22 |
posted on 11th Jul 05 at 09:33 |
I'd guess it would be a straight swap as you are using after maret management what sensors are you using? | |
RobHayes |
posted on 11th Jul 05 at 09:12 |
what i wanted to do was to put the TBs and management on the x16, and then put the standard inlet + exhaust off the x16 onto the c16 to hopefully make a working engine which i could rebuild and then sell | |
Cybermonkey |
posted on 11th Jul 05 at 08:24 |
Rob, Loom and ECU will be a problem, since there are subtle changes between X16 and C16, such as idle control settings. Also, the block differs slightly between both, and not forgetting EGR and stuff. You might be better off just transferring the TB's and getting new engine on a dyno to recalibrate the management. Exhaust should be a straight swap. | |
Adam-D |
posted on 11th Jul 05 at 08:01 |
what tb's are they? | |
RobHayes |
posted on 10th Jul 05 at 18:29 |
i currently have a knackered c16xe on TBs. have been offered a x16xe for next to nothing. im assuming i would be able to swap the TB's, exhaust and management over from the c16 to the x16? |