|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Dash water temp guage » Post Reply
|
TOMAS |
posted on 14th Mar 05 at 18:03 |
No worries oh and if you do replace the temp sender PLEASE be carefull as mine sheared off in two flush in the stat housing !! Maybe give it some WD40 treatment 1st... | |
Jambo |
posted on 14th Mar 05 at 15:03 |
cheers tomas :D | |
TOMAS |
posted on 14th Mar 05 at 12:47 |
Right the way to test it if I remember rightly is to remove the small female spade connector from the sensor - its in the thermostat housing next to the CTS. Touch that spade connector to a clean earth in/around the sensor area and the needle on the dash gauge should shoot up to max temp. If its not moving then its NOT the sensor at fault its the wiring/gauge itself. New sensor is only approx £10-£15 anyhow. | |
Jambo |
posted on 14th Mar 05 at 12:22 |
posotive its not working, the needle doesnt move. | |
Dave A |
posted on 14th Mar 05 at 12:10 |
u sure its not working at the dash end? | |
Jambo |
posted on 14th Mar 05 at 12:08 |
Is broken :| |