|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Removing Front seats on >97 sport » Post Reply
|
Stu_22 |
posted on 19th Jun 04 at 21:36 |
If your just swapping corsa seats id just undo the 4 bolts holding the seats to the subframe | |
Jambo |
posted on 19th Jun 04 at 19:34 |
Right i need a rachet with torx heads basically, my drill couldnt do it. | |
sfxer |
posted on 19th Jun 04 at 14:16 |
p.s how are you trying to do it with a screwdriver? its a female torx bit thats needed | |
sfxer |
posted on 19th Jun 04 at 14:16 |
the bolts can be very tight, i took mine out recently and need new bolts allround as they pretty much rounded off. | |
koolkorsa |
posted on 19th Jun 04 at 08:35 |
took my about 10 hours to swap my seats over! I was trying to undo the 4 bolts rather than the 2 and lifting whole lot out. Wish i'd known that tip at the time! | |
Chris R |
posted on 19th Jun 04 at 06:20 |
because you can remove two T30 torx bolts put the tensioner locks on the seatbelt pretensioners and lift out. takes 10 minutes max. | |
mike_1.2LS96 |
posted on 19th Jun 04 at 00:21 |
I dont understand why some people dont just remove the four bolts under the seats that attach it to the subframe. Unless your removing the subframes, to change seats you just leave them in... | |
corsa_godfather |
posted on 19th Jun 04 at 00:00 |
look underneath car will see the rest of the bolt.its bolted through the floor.spray WD-40 underneath and at top of the bolt then turn it like a bitch lol | |
Stu_22 |
posted on 18th Jun 04 at 23:56 |
Get a ratchet with torx heads from halfords I managed it | |
Jambo |
posted on 18th Jun 04 at 18:56 |
How in the rabbit do you get those fecking bolt off? They are like fucking welded to the floor :mad: |