|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Has any1 hooked up a Shift light to a C » Post Reply
|
James R |
posted on 11th May 04 at 09:23 |
normally you'd find where the engine loom meets the car loom and look at th e9-pin plug for the green wire, btu if the corsa C doesn't have this setup then you'd need to connect the shiftlight to one of the -ve coil feeds, then switch it to 2cyl and it will work fine. | |
FrankP |
posted on 11th May 04 at 07:43 |
yeah it's a multi coil but can't find the tacho signal, probed justabout every wire there was and nothin. I know the shift light is working coz i tried it on a car with a dizzy. | |
James R |
posted on 11th May 04 at 07:31 |
3) tacho signal, usually from the negative terminal on your ignition coil. If you own a multi coil car you will only need to locate the tacho signal from your computer which will be avalible either from the wiring loom near the computer itself or from the ign power module | |
FrankP |
posted on 11th May 04 at 07:25 |
it don't work like that. | |
James R |
posted on 11th May 04 at 07:21 |
connect it directly to the oil pack and switch it to a 2cyl config on the shift light, only connect one of the -ve feeds from the coil. | |
FrankP |
posted on 11th May 04 at 07:19 |
You guessed correctly. I've been trying since last thurs to work it out. oh well guess my process of illimination continues. When i get the thing working i'll post a how to. | |
corsa3.0v6 |
posted on 11th May 04 at 00:40 |
think your goin 2 struggle there cos the engine control unit sends a signal to the body control module which then sends a signal to the instruments!! Goin to be a bit of a nightmare to work out. | |
FrankP |
posted on 9th May 04 at 11:37 |
as above. I've looked thru the Corsa C TIS and there are only speed signals which don't work with my shift light. |