|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » filling bodywork how hard ? » Post Reply
|
STEvieXE |
posted on 29th Dec 03 at 17:15 |
yeah leave it in primer for as long as poss b4 painting to see if it will sink. and if u could try and get alot of heat onto it. deff use the rite grades of paper or it will sink back in a few months and u will see all he repair scores | |
Kris TD |
posted on 29th Dec 03 at 16:53 |
quote: defo, and if you use to much filler, give it a couple of weeks and it might sink. | |
Rainesie |
posted on 29th Dec 03 at 15:32 |
I kinda figured on that anyway. Bit like fitting your 6x9's.:D | |
johns purple beast |
posted on 29th Dec 03 at 15:15 |
yeah hours of sanding :) pete u can do that part while i watch ;) | |
STEvieXE |
posted on 29th Dec 03 at 14:40 |
fillings easy. its the leveling after thats the hard part | |
Rainesie |
posted on 29th Dec 03 at 14:21 |
I'll give you a hand sometime if you want, doesn't come with 100% success guarantee though. I'm alright with filling and rubbing down, don't know about the rusty area's. | |
johns purple beast |
posted on 29th Dec 03 at 13:26 |
yeah it is pete loads little 1s all ova the place :lol: wanna get rid of sum rust enall | |
Rainesie |
posted on 29th Dec 03 at 12:45 |
quote: Are you sure you want to try it flower :P Are these the dents on your rear left quarter? | |
Kris TD |
posted on 29th Dec 03 at 11:16 |
i had a bad dent in my rear 3/4 panel where some kunt drove into me, knocked most of it out and used a tiny bit of filler, cant tell it was ever dented. | |
Kris TD |
posted on 29th Dec 03 at 11:15 |
how bad are they? most things can be pushed out a fair way, infatc there are companies which specialise in that stuff without need for respraying. if you want too though i recommend getting a panel beating kit, knock it out as much as you can to minimise filler use. then key area, filler if then sand etc.... | |
johns purple beast |
posted on 29th Dec 03 at 11:11 |
got sum dents i wanna try filling as dont think they can b pushed out anyone got any ideas wot to use ??? |