|
wayne hiscock
|
posted on 20th Nov 03 at 01:12 |
jl
i want a 500/1 and another w3
need too sort all the rattles out with one w3 first tho
|
Andy GSi
|
posted on 19th Nov 03 at 12:20 |
well i think i will just go for ALL JL audio equipment!
|
break
|
posted on 19th Nov 03 at 12:11 |
Its no competition... JL by far. I can't believe you could even consider DLS. That said, I would also look into Audison as well. My next amp will either be Audison or JL.
|
SteveW
|
posted on 19th Nov 03 at 00:29 |
they are both very very good amps. I am bias tho and would say to get JL Audio as i have a boot full of it ;)
The subs are FAB, i have only blown 1 JL in all the time i have had mine :lol: (about a year and a bit now)
They do drop wickedly (if run correctly, like our big man trotty)
So yeah GO GO JL
|
Trotty
|
posted on 18th Nov 03 at 20:05 |
I've got the 500/1 running 2 JL 12W3-V2D2's and its great IMO - thoroughly recommended :)
|
DIGGIDY
|
posted on 18th Nov 03 at 14:35 |
JL subs have one flaw they can't handle dirty signals very well for long periods, so a good clean signal amp is essencial...
|
DIGGIDY
|
posted on 18th Nov 03 at 14:31 |
JL all the way... super clean sound, excellent quality...
|
broster
|
posted on 18th Nov 03 at 12:50 |
id go with dls, i have a dls 4 channel amp and i love it
|
Andy GSi
|
posted on 18th Nov 03 at 10:34 |
its either these two AMPS to power 2 12" jl's. I NEED YOUR HELP ON CHOOSING WHICH ONE IS THE BEST???? the JL will suit the install because then everything would be JL!!!
JL subs SPEC:
Nominal Diameter: 12 inches (300 mm)
Continuous Power Handling: 300 Watts
Voice Coil: 2.25" diameter, 4-layer, Kapton former
Configuration: Dual 2 ohm
Xmax (one-way, linear): 0.46"-0.51" (11.7-13.0 mm) depending on specific model
Sealed Enclosure Range: 1.00-1.50 cu.ft. (28.3-42.0 liters)
Ported Enclosure Range: 2.00-3.00 cu.ft. (57.0-85.0 liters)
VRC™ Technology: YES
Elevated Frame Technology: YES
Rated Power: 500 W RMS @ 1.5 ohm-4 ohm (11V-14.5V)
THD at Rated Power: <0.05% @ 4 ohm
S/N Ratio*: >95dB below rated power
Frequency Response: 5 Hz-500 Hz (+0, -1dB)
Damping Factor: >500 @ 4 ohm/50 Hz
Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS
Dimensions: 13.4"L x 9.25"W x 2.36"H
Differential-Balanced Input Topology: (1 pair of inputs)
On-board Crossover: fully-variable (40-200 Hz), selectable-slope LP (12 or 24 dB per octave)
Preamp Output: 2-channel (independent active filter, parallel with amp filter or full-range)
Bass EQ: parametric with variable boost up to 15dB and Remote Bass Control (optional)
Infrasonic Filter: fully-variable 24dB/octave from 15-60 Hz
Signal-Sensing Turn-On: permits operation without remote lead
Dual mono speaker output connections: accept up to 8ga. wire
+12V and Ground connections: accept up to 4ga. Wire
Monoblock Amplifier
1 x 500W RMS (4 ohm)
1 x 870W RMS (2ohm)
1 x 1200W RMS (1ohm)
Includes remote bass control
|