|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » General Chat » Bonnet Louvers............ » Post Reply
|
taylorboosh |
posted on 20th May 12 at 17:52 |
It would be just near pass front headlamp | |
Corsa_Sport21 |
posted on 20th May 12 at 17:50 |
I reckon it would look shit on an M3 tbh. Just with the way the bonnet is with the big bulge in middle. | |
taylorboosh |
posted on 20th May 12 at 17:09 |
Was just if i get a cone filter if want to force cold air in | |
BeArDy |
posted on 20th May 12 at 16:16 |
They are there to help heat flow out of the bay, as the front of the car sucks in far more air than any vent would. | |
Corsa_Sport21 |
posted on 20th May 12 at 15:18 |
Maybe its so the heat flows out....... | |
taylorboosh |
posted on 20th May 12 at 15:14 |
the only issue i have is the dont look like they will flow air into an engine bay, can you do them so the louvre is inside the bonnet? | |
BeArDy |
posted on 19th May 12 at 21:16 |
yes mate, paint will be damaged once pressed. | |
IvIarkgraham |
posted on 19th May 12 at 21:15 |
guessing it £104 plus what it costs to paint? | |
Darryl H |
posted on 19th May 12 at 21:06 |
They look great :) | |
bigron1988 |
posted on 19th May 12 at 20:34 |
fancy a go on my bonnet :lol: | |
IvIarkgraham |
posted on 19th May 12 at 19:47 |
looks good | |
taylorboosh |
posted on 19th May 12 at 19:46 |
not a bad price | |
BeArDy |
posted on 19th May 12 at 19:37 |
Same price as Cool Louvers charged £5 first 10 then £3 each over that. | |
kennySRi |
posted on 19th May 12 at 19:34 |
That's a great idea and looks to be a decent job :) | |
taylorboosh |
posted on 19th May 12 at 19:30 |
How much per bonnet? | |
JaffaTB |
posted on 19th May 12 at 19:27 |
looks mint that mate, i want a wing done like that :) | |
BeArDy |
posted on 19th May 12 at 19:25 |
So started on the bonnet for the twin engine corsa. I wanted to louver the bonnet as i think its very suttle, after doing alot of research no one where pressed louvers anymore into curved panels; load of places will do flat panels but as soon as you can curved bonnet etc they all say they are unable as it will press square corners from the outside edges of the tool around the louver. I did not want to weld in a louver plate eather. |