|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » General Chat » fitting a spoiler ?? advise ? » Post Reply
|
N3CRO |
posted on 24th Jul 11 at 22:33 |
Mine was just bolted on. | |
Jed D |
posted on 24th Jul 11 at 22:31 |
quote: done that before, lost it at about 70 hahaha | |
Jonny.K |
posted on 24th Jul 11 at 22:28 |
tiger seal everytime | |
Pryce12345 |
posted on 24th Jul 11 at 18:50 |
Tiger seal ftw | |
bensterzback |
posted on 24th Jul 11 at 07:13 |
I fitted mine last night removed the original screws used double sided tape to hold it in place and tiger sealed the top two corners and bottom two corners and i plan to run 140+ db of bass through mine :) | |
Chris F |
posted on 23rd Jul 11 at 22:39 |
Going back a few years (1.2 8v) drilled boot and used STD fixings, think I may have bonded it on as well! | |
Sean |
posted on 23rd Jul 11 at 22:01 |
i cut the bits for the screws off my spoiler put a bit of double sided tape on in places loada tigerseal worked a treat :D | |
Daveskater |
posted on 23rd Jul 11 at 21:52 |
I riveted the black bit on and tigersealed the spoiler on, worked absolutely fine. If you do fit the black bit then you'll need to make a hole below the washer jet for the water to go through as the pipe on a car not built with the spoiler isn't long enough to reach the jet on the black bit. | |
andyc1234 |
posted on 23rd Jul 11 at 18:51 |
i stuck mine on with bathroom sealant. didnt bother with the black plastic bit. sounds like your being robbed tbh | |
Jed D |
posted on 23rd Jul 11 at 18:46 |
dont put one on, look better without imo | |
tom130691 |
posted on 23rd Jul 11 at 17:41 |
realy strong silicone hold my skirts on, the bigg rubber ones not fiberglass | |
kyleclub11 |
posted on 23rd Jul 11 at 17:31 |
quote: is that just a strong glue i take it ?? :boggle: | |
FAZ |
posted on 23rd Jul 11 at 17:27 |
everyone else manages, presuming a standard gsi/sport jobby onto a 3door corsa b? | |
tom130691 |
posted on 23rd Jul 11 at 17:21 |
tigerseal it on | |
kyleclub11 |
posted on 23rd Jul 11 at 17:18 |
i bought a spoiler and i seen some guy how to fit it and he said the top of the tail gate is not long enough near the rear washer jet to fit the black base with self tapers ?? |