|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » General Chat » Turbo Nutters » Post Reply
|
J da Silva |
posted on 2nd May 04 at 08:44 |
i thank thee mr ross | |
vibrio |
posted on 1st May 04 at 20:56 |
oil pressure will be high once moving BTW for my car it's about 2.5bar while at idle goes up t around 6 or 7 bar once on the move I think. oil temp will be up to temp after around 15 mins of driving. takes ages at idle to get up to temp | |
J da Silva |
posted on 1st May 04 at 18:47 |
nah :lol: | |
vibrio |
posted on 1st May 04 at 13:39 |
quote: 1 bar with uprated actuator then like it says on the page for wallace perfomance. I would have checked there first like I did :lol: | |
J da Silva |
posted on 1st May 04 at 13:29 |
you get a FMIC with the upgrade | |
vibrio |
posted on 1st May 04 at 13:27 |
you using standard IC or an bigger FMIC. | |
J da Silva |
posted on 1st May 04 at 13:20 |
he put an evo 2 wallace software upgrade in, kentcam kit and replaced the journals in the turbo | |
vibrio |
posted on 1st May 04 at 12:00 |
1000rpm at idle seems a bit fast :lol: | |
J da Silva |
posted on 1st May 04 at 09:24 |
yeah i know fads, i think they're all hungover though :lol: | |
Fad |
posted on 1st May 04 at 09:23 |
post on MIG some very wise ppl on there | |
J da Silva |
posted on 1st May 04 at 09:22 |
nah not running standard boost, that was already modded when i bought the van, although i've had to slow the engine speed at idle down to 1000 revs as it was running a bit too fast, when i set off at slow speed it was quite jumpy :( | |
vibrio |
posted on 1st May 04 at 09:19 |
does it not overboost to 0.8bar then run at 0.6 bar as standard. as for fueling don;t know :lol: you could probabyl get way with increasing it slightly via an uprated actuator | |
J da Silva |
posted on 1st May 04 at 09:16 |
:lol: we're stumped | |
Marc |
posted on 1st May 04 at 09:14 |
^ | |
Mattb |
posted on 1st May 04 at 09:11 |
i dunno....... | |
J da Silva |
posted on 1st May 04 at 09:10 |
whats a suitable psi for the oil pressure on a c20let and what temp is the oil safe at idle? |