|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Brake distribution block? » Post Reply
|
Jed D |
posted on 20th Feb 15 at 10:16 |
13"s fit over them well though :D | |
Jed D |
posted on 20th Feb 15 at 10:14 |
yeah, i wasnt sure, with mine being only fronts i was going to use one pipe to the left and one to the right but just to be sure i kept them in the block bit and just blanked the rears off | |
jay.jay |
posted on 18th Feb 15 at 14:15 |
I think it has 2 lines that are split diagonally across the car, so that if one fails then there is still a pair of working brakes on the car. I think that's why there's 2 anyways, could be completely wrong mind haha | |
Jed D |
posted on 18th Feb 15 at 08:48 |
while we're on the topic, i have a question... | |
sparcost3 |
posted on 18th Feb 15 at 06:10 |
i got rid of that random block and the spring loaded thing welded to a mount on the rear wheel well of the car whicj i also cut out and welded over. | |
jay.jay |
posted on 16th Feb 15 at 18:22 |
Haha yeah I'll check dw :p should be fine | |
Jed D |
posted on 16th Feb 15 at 00:28 |
id imagine so yeah mate, double check which goes to which side on the rear though, i bare no responsibility here if you do it wrong :P | |
jay.jay |
posted on 15th Feb 15 at 11:26 |
Ah cool, so as long as I fit 2 T pieces in place of it all should be good! Yeah the threads are fucked hence why I want to get rid of the stupid thing lol | |
Jed D |
posted on 15th Feb 15 at 09:29 |
the 'in' on the top is the 'out' on the same side irrc, never traced the lines back to find out which side it went to cos i just removed the rears all together and blanked them off.... | |
jay.jay |
posted on 13th Feb 15 at 22:18 |
I'm in the process of replacing all the brake hoses on my corsa b with braided Teflon hose and fittings, can I just replace the distribution block on the bulkhead with some Y piece connectors or does it split the fluid here into the opposite corners? Reason for asking is the distribution block is corroded badly so would rather just get rid of it all together if possible |