|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » e16se into corsa b 1.2 8v » Post Reply
|
Spencer627 |
posted on 21st Sep 12 at 14:20 |
the top one is bloody awesome, makes me wanna get rid or my xe and drop one of those in lool | |
JaffaTB |
posted on 21st Sep 12 at 06:04 |
the top one? its not fully finished lol | |
Spencer627 |
posted on 20th Sep 12 at 22:29 |
sooo much space in that bay lol | |
JaffaTB |
posted on 20th Sep 12 at 21:33 |
| |
JaffaTB |
posted on 20th Sep 12 at 21:25 |
i think its easier to run them on the e16 mate but not too sure | |
gav93 |
posted on 20th Sep 12 at 21:13 |
what do you mean buy one of what air intake pipe mate? | |
JaffaTB |
posted on 20th Sep 12 at 21:13 |
only difference between the e and the c16 is the ignition system, AFM compared to MAP sensor, and lambda compared to no lambda | |
JaffaTB |
posted on 20th Sep 12 at 21:11 |
yes mate all the sensors bar one are in the exact same position, and the one that isnt is only on the air intake pipe so you can just buy one and put it onto where it is on the corsa | |
gav93 |
posted on 20th Sep 12 at 21:02 |
hmm ok mate i will probs go for a decent c16 lump so al li will need to do is get hold of a sri loom and literally just swap that over ? | |
JaffaTB |
posted on 20th Sep 12 at 20:59 |
not sure with the e16se, but with my c16se i got hold of a corsa 8v sri (c14se) engine loom and used that as its exactly the same engine with with a bigger bore, that way its plug and play no messing with wires | |
tom130691 |
posted on 20th Sep 12 at 15:25 |
mine not done yet im collecting parts, | |
gav93 |
posted on 20th Sep 12 at 10:01 |
well got a set of carbs sitting here all i need is an engine block and head i can build up the rest ideally | |
tom130691 |
posted on 19th Sep 12 at 22:26 |
would also be intrested in this, | |
gav93 |
posted on 19th Sep 12 at 20:49 |
whats the craic on doing this wiring wise, i know it will fit on my mounts box shafts im stumbled at what to do wiring wise though just want to make sure i know what im doing or have a vauge idea before i start.. |