corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Heater Matrix » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

Ian

posted on 28th Feb 11 at 22:26

Depends how bad the leak is.

You could also bypass it by taking the pipes off at the bulkhead and looping one back on to the other so the water doesn't enter the dash.

Won't have any heat then of course, but is also won't leak.


chrisritch

posted on 28th Feb 11 at 20:48

also, down on coolant a little bit, if i keep topping up until my new matrix arrives should it be ok?


chrisritch

posted on 28th Feb 11 at 18:40

Why would there be steam coming out of the vents :boggle:


pow

posted on 28th Feb 11 at 18:13

Yus blud.


chrisritch

posted on 28th Feb 11 at 18:03

so as i put it the small radiator looking thing then


Lee Wilson

posted on 28th Feb 11 at 17:56

Its up in under the dash. The heater matrix. With two pipes on.


pow

posted on 28th Feb 11 at 17:55

Then matrix is the bit that makes the air warm, the fan the bit that moves the air.

It's a wankstain to do


chrisritch

posted on 28th Feb 11 at 17:49

Turned my heaters on and was only de misting one side, the smoke/steam started coming out and the floor is wet, I have been told this could/probably will be the heater matrix. my question is which bit do i replace? the small radiator looking thing or the actual blower motors etc?

will delete asap just need an answer fast