|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » seat and seat belt pre-tensioner removal » Post Reply
|
Haimsey |
posted on 7th Apr 13 at 17:16 |
quote: The red fork should be removed once it is back in situ. | |
Mr Turner |
posted on 7th Apr 13 at 14:47 |
The only red fork like clip i can see is at the rear of both the drivers and passengers seat attached to what i assume is the pretensioner. My question is when the pretensioner is fitted and working correctly should the red clip be fitted? As mine are? Or should they be removed as mentioned in this thread? | |
corsa-torque |
posted on 6th Apr 13 at 16:54 |
It's a red fork of plastic, and I'd truly advise fitting it before removal, otherwise it may go off and trust me it goes with a bang, left me with a ringing in my ear for hours. | |
Mr Turner |
posted on 6th Apr 13 at 12:36 |
Realise this is old but i need to replace the seat belt pretension on my corsa b. What is the clip that keeps getting mentioned and what does it do? Thanks. | |
tomt08 |
posted on 18th May 10 at 21:12 |
Remove the sill plastics at the side of the seat to do this lift the flap and there shud be two t25 screws then there is one behind the seat on the same piece of plastic and one in front. Once you have done this take the plastic out of the way and move the seat forward. Place the clip in the pretensioner. Then there are two t40 torx screws one at the end of either rail behind the seat, undo both of these. Then move the seat back lift it at the back and push forward this should now be off all the mount and you can remove it from the car. Fit the new pretension remembering to put the clip in and then putting the seat back is the opposite of removal. However make sure you remember to take the clip back out of the pretensioner once youve finished | |
ali_corsa |
posted on 18th May 10 at 20:15 |
40 torx to get the whole seat frame out might need a racher or battery gun | |
westcoastcorsa |
posted on 18th May 10 at 20:12 |
i am new to all this lol | |
am4nf |
posted on 18th May 10 at 19:56 |
get one from a scrappies or something | |
westcoastcorsa |
posted on 18th May 10 at 19:31 |
quote: what if there isnt one :o key that is [Edited on 18-05-2010 by westcoastcorsa] | |
am4nf |
posted on 18th May 10 at 19:26 |
oh and remove it once you have fitted | |
am4nf |
posted on 18th May 10 at 19:26 |
torx bits, and remember to put the key in the pre-tensioner | |
westcoastcorsa |
posted on 18th May 10 at 19:14 |
need to put a new seat belt tensioner on my corsa, just wanting to know how hard and whats needed for removal of the seat and seat belt pre-tensioner, cheers |