|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » removing locking wheel nuts without the locking wheel nut key » Post Reply
|
x14xe ry |
posted on 30th Jul 09 at 22:38 |
chisel and a hammer done the job in the end cheers for all ya help | |
harrisp |
posted on 30th Jul 09 at 21:50 |
exactly what he said, just find a socket the wont quite go on then hammer it on, put an short extension on to avoid damaging your wheel when hammering/ | |
adz_gsi |
posted on 30th Jul 09 at 21:28 |
then either a breaker bar or air gun /battery gun mate hth | |
adz_gsi |
posted on 30th Jul 09 at 21:27 |
if its the old style locking nut then a six sided single hex 16mm socket and hammer it over the head or if its the new style one with a collar that spins then a 24 mm socket | |
sampayne21 |
posted on 30th Jul 09 at 09:44 |
take it to any good alloy wheel shop, they can use an airgun to take them out | |
x14xe ry |
posted on 29th Jul 09 at 20:19 |
tired that there too small to fit round the head we got off with a flat head screw driver and hammer | |
Liam B |
posted on 29th Jul 09 at 19:55 |
Some locking wheel nut extractor kits at halfords, dont know what they work like though. | |
x14xe ry |
posted on 29th Jul 09 at 19:52 |
is there a easy way to remove a locking wheel nut if you havent got the locking wheel nut key? im going mad any help welcome |