|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » 2.5 v6 rwd corsa ? » Post Reply
|
DAZ1985 |
posted on 28th Apr 08 at 19:31 |
if it was rear mounted with an f20 box then it would be rwd | |
swill_omnibus |
posted on 28th Apr 08 at 19:27 |
quote: Why don't you try that in a corsa combo? | |
jay@4thecruise |
posted on 28th Apr 08 at 18:46 |
just chose corsa b because ave always liked them , any other options guys ? astra ? corsa c ? astra van ? just looking for a project , sumthing different , and preferably rwd , if it comes to it a would even convert to one of the fwd boxes , did think about rear mounting it but the engine,box,diff combined lengh is a bit long , a think longer than could possible fit in a corsa's boot anyway | |
DAZ1985 |
posted on 28th Apr 08 at 17:58 |
Alot of work imo | |
scottc1088 |
posted on 28th Apr 08 at 15:37 |
if your thinking of a corsa b then the omega front subframe wont bolt on as the corsa doesnt have a subframe | |
fazza |
posted on 28th Apr 08 at 12:28 |
not without lots of work i dont think. im currently doing a 5stud conversion on my corsa(which all omegas are) and i couldnt use any omega bits as none of them fit | |
jay@4thecruise |
posted on 28th Apr 08 at 12:19 |
thats another bit a needed sum answers on , a havent looked at the corsa front chassis and subframe in a while , just an idea a had instead of going the fwd root , fancied a challenge :lol:, would the omega subframe bolt upto the corsa chassis ? | |
fazza |
posted on 28th Apr 08 at 12:05 |
iirc the omega setup cant be used with corsa bits for hubs etc. so will be fooking loads of work mate. | |
jay@4thecruise |
posted on 28th Apr 08 at 12:03 |
ok folks need a bit of advice here , basicaly a have a full omega estate 2.5 v6 ecotech sitting in my garage with crash damage to the front , had an idea to transplant the full running gear into a corsa , was thinking cutting the transmition tunnel out the omega shell and welding it into a corsa shell , shortening the propshaft and mounting the diff/axle on the rear of the corsa , just an idea for now , looking for sum feedback before a buy a corsa shell , a know its lots of work but i am a fabricator/welder by trade so dont mind the welding involved , has this been done before ? a have seen a few v6's in corsa's with the fwd gearboxes but never seen a rwd corsa apart from the handfull off rear engine ones , help :D |