corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Crank Angle Sensor (CAS) Incorrect RPM signal » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

Jas

posted on 26th Feb 06 at 22:36

the car starts etc..

just in limp mode..

wont exceed 4k rpm and it cuts out itim driving it... will run in neutral fine without giving it revs..


Adam-D

posted on 26th Feb 06 at 22:19

you always get crank angle sensor thou
as the car aint runing

what the problem with the car?
not starting?
if so have you got the immob chip, ignition ring and matched ecu?


Jas

posted on 26th Feb 06 at 22:05

quote:
Originally posted by broster
quote:
Originally posted by Rob B
might have got dirty..


its a magnet..... dirt shouldnt really effect it

well im hoping it would affect it lol.. gonna give it a clean tomorrow!


Jas

posted on 26th Feb 06 at 19:19

cheers mark.. il have a look tommorow as its too dark no.. did attempt but by using a shitty little torch lol


broster

posted on 26th Feb 06 at 18:59

quote:
Originally posted by Rob B
might have got dirty..


its a magnet..... dirt shouldnt really effect it


broster

posted on 26th Feb 06 at 18:59

as suggested yesterday look att he crank sensor and check the timing if its getting the incorrect rpm signal the timing could be out


Jas

posted on 26th Feb 06 at 18:36

take it out clean it?


Rob B

posted on 26th Feb 06 at 18:33

might have got dirty..


Jas

posted on 26th Feb 06 at 18:33

ok so il need to get under the car?


Dave A

posted on 26th Feb 06 at 18:31

timing belt side, closest point to the floor.


Jas

posted on 26th Feb 06 at 18:30

ok where by in the engine bay is that then mate? it was fine just gone all of a sudden so doubt it was done in the process of the converison maybe later on?


Dave A

posted on 26th Feb 06 at 18:28

following on from your u2u's jason, i thought i would post this up. its a pic of the crank sensor. (bottom right bit sticking out with the wire going to it)
check its on tight and not damaged. sometimes gets knocked about when doing a conversion due to the position of it.


Jas

posted on 26th Feb 06 at 18:19

*****85****

*****19****


immob wrong signal

and

Crank Angle Sensor (CAS) Incorrect RPM signal


[Edited on 27-02-2006 by Jason2004]