|
ed
|
posted on 22nd Jul 05 at 20:44 |
Also, a small bit of grease should be put on the fuel lin nipple threads to stop then getting even more corroded ;)
|
ed
|
posted on 22nd Jul 05 at 20:43 |
They should fit onto the XE fuel line nipples. THe return pipe that goes into the fuel pressure regulator needs a few "s chopped off of it. If you attatch the feed to get it out of the way then cut the return pipe at the plastic pipe just after where the crimp for the rubber part is attatched, then chop the crimp off - cutting enough off the shorten the pipe enough, then slide it onto the plastic pipe and fasten it with a jubilee clip.
|
corsapaul
|
posted on 22nd Jul 05 at 20:13 |
the 1 1that goes to the drivers side, tou need to cut a couple of inches off the blue pipe and then slide the rubber hose on.
|
the_legend_of_yrag
|
posted on 22nd Jul 05 at 10:53 |
Heres my fuel lines from my car, they used to bend into the side of my old 8v fuel rail but the xe fuel rail they go in from the back of the fuel rail.
Do i have to use the nipples in the fuel rail?
Whats the best way to get them to the xe fuel rail?
cheers
|