|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Again!!! » Post Reply
|
MikeH |
posted on 20th Feb 04 at 02:08 |
Will this be covered under a network Q garauntee? | |
essexracer |
posted on 19th Feb 04 at 23:58 |
quote: does she :! :! :! i suggest u wear glasses m8! or teach her to like it up the wrong en! james :P | |
BabyBlade |
posted on 19th Feb 04 at 23:20 |
quote: I got the same problem :( :lol::thumbs: | |
MOB |
posted on 19th Feb 04 at 23:14 |
yea i thought that afta i got it fixed, bill was huge but wouldn't pass MOT legit! | |
MikeH |
posted on 19th Feb 04 at 23:06 |
maybe i should just decat it :P | |
MikeH |
posted on 19th Feb 04 at 23:05 |
So your power loss was cos you had a big hole in your exhast quite high up? | |
MOB |
posted on 19th Feb 04 at 23:03 |
not sure wot it is but some sensor somewhere, fumes from my CAT had fecked the sensor up so might b the one in the manifold i was thinkin? | |
MikeH |
posted on 19th Feb 04 at 22:54 |
Sensor just above the cat? is that the EGR valve? | |
MOB |
posted on 19th Feb 04 at 22:52 |
o yea mine is a 1.0 12v | |
MOB |
posted on 19th Feb 04 at 22:51 |
had a similar problem, check that the CAT ain't cracked and blowing and check the sensor just above CAT its just cost me a small fortune to repair, 3 days work at local garage! | |
MikeH |
posted on 19th Feb 04 at 22:47 |
Right, i've been told the ecu for the 1.0 12v and 1.2 16v is a motronic 1.5.5 and is different to all the other ones. It has no L line on the diagnostic plug and only a K line. | |
miles |
posted on 19th Feb 04 at 22:27 |
If you dont have the pin the tech 2 wont be able to connect. If you look under it you will see if there is a wire going into the connector. You can just connect the wires. | |
LukeGSi |
posted on 19th Feb 04 at 22:15 |
quote: thats what the g/friend says all the time :o :lol: | |
essexracer |
posted on 19th Feb 04 at 22:13 |
well thats weird...maybe thats coz ur tryin the wrong hole? | |
MikeH |
posted on 19th Feb 04 at 22:07 |
ok i tried the paperclip test but one of the pins your supposed to bridge has no metal contact in it! | |
essexracer |
posted on 19th Feb 04 at 22:00 |
quote: y cant u use the paper clip test? i assume uv tried? :boggle: maybe u were puttin the paperclip in the wrong pin holes? :boggle: i think its £34 at vaux for a read out, well it is at my local one....but i use the paper clip :) james | |
BabyBlade |
posted on 19th Feb 04 at 21:44 |
erm the ecu light flashed on and off when my throttle position sensor (think it was called that) went, it eventualy stayed on all the time | |
stuyw |
posted on 19th Feb 04 at 21:24 |
30 notes to go on the diag machine | |
MikeH |
posted on 19th Feb 04 at 21:13 |
How much am i likely to be ripped off for to get vauxhall to diagnose it? | |
Gavin |
posted on 19th Feb 04 at 21:10 |
hmmmmmmmmm......... usually the ecu shows sumthing wrong with the air flow.... but u sed it cant be that!!!! :boggle: | |
MikeH |
posted on 19th Feb 04 at 21:07 |
not the airflow meter, checked it. | |
BabyBlade |
posted on 19th Feb 04 at 21:06 |
hmm full throttle? | |
MikeH |
posted on 19th Feb 04 at 21:01 |
:( | |
MikeH |
posted on 19th Feb 04 at 19:49 |
Drove to B&Q just now and the engine management light came on twice :( |