|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Engine Cutting out corsa 1.2 8v » Post Reply
|
dysonm |
posted on 18th Dec 03 at 18:17 |
had this last month check your plud and clean the caps | |
corsaboynick |
posted on 18th Dec 03 at 17:42 |
Right ok il look in to it sounds really similar to what mine is doing. | |
Siberia22 |
posted on 18th Dec 03 at 15:53 |
i had the same problem with my 1.2 8v. iff you stab the accelerator when stoped it trys to cut out like as if there wasent enough petrol getting through if u push it smoothly its not bad? | |
corsaboynick |
posted on 18th Dec 03 at 15:03 |
cool cheers il check them out | |
Adam-D |
posted on 18th Dec 03 at 15:00 |
check the map sensor pipe this can cause it to cut out also chack all vacumm pipes for splits | |
corsaboynick |
posted on 18th Dec 03 at 14:30 |
cheers mate | |
whitter45 |
posted on 18th Dec 03 at 14:29 |
ok mate good luck it semed to work for me | |
corsaboynick |
posted on 18th Dec 03 at 14:27 |
no i havent got an induction kit but i know wot bit u mean i might try fiddling with that then next time it starts playing up | |
whitter45 |
posted on 18th Dec 03 at 14:26 |
have u got an induction kit on the engine. | |
corsaboynick |
posted on 18th Dec 03 at 14:16 |
ok cool cheers for your help | |
sunnyb |
posted on 18th Dec 03 at 14:16 |
greasemonkeys good for that kinda stuff ask him buddy | |
sunnyb |
posted on 18th Dec 03 at 14:15 |
all the time but if i let it idle for a min or 2 then its fine! im not very mechanical but that happens to mine! but after 10mins should be sweet! | |
corsaboynick |
posted on 18th Dec 03 at 14:13 |
had been ideling for about 10 mins cos i was deicing my car at the time. Do you have this problem regularly then? | |
sunnyb |
posted on 18th Dec 03 at 14:11 |
let it idle for a few mins thats what happens to mine pain in ze arse mate | |
corsaboynick |
posted on 18th Dec 03 at 14:07 |
I start my engine it turns over fine runs fine touch the accelerator and it starts juddering, turning over slowly and engine stalls as if not enough or too much fuel is getting into cylinders turn it back on and it starts reving at bout 2000rpm then touch the accelerator again and engine stalls. As its an intermittent fault its hard to determine what it is without taking everything apart just wondering if anyone else has had this problem and what did you do to sort it out? |